The Go to product viewer dialog for this item. is a celebrated dual-stage mastering limiter developed by PSP Audioware. Achieving maximum loudness while keeping a transparent mix requires leveraging its distinctive architecture: an integrated leveler, a predictive transient section, and two distinct limiting stages. The definitive roadmap to pushing maximum loudness out of consists of the following core steps: 1. Enable Oversampling & Second-Order Filters
Set the internal filters to 2nd order to drive the internal limiters accurately.
Turn Oversampling ON. This activates true-peak limiting, ensuring inter-sample peaks don’t clip streaming platforms while driving the volume up. 2. Configure the Two-Stage Limiting
Understand that Xenon splits the workload. The first stage applies the bulk of the gain reduction while letting fast transients pass through cleanly.
The second stage acts as a fail-safe brickwall limiter to catch the remaining peaks. This split design prevents the pump-and-distortion artifacts common in single-stage limiters. 3. Adjust the Transient Mode for Loudness
Switch the transient control section to Predictive Mode (B or C). Avoid Mode A if you are pushing for sheer loudness.
Set the slider to 50% to 70% predictive look-ahead. This smooths out incoming transient peaks while retaining punch and clarity.
Keep the release time relatively short to allow the limiter to recover quickly between audio peaks, raising perceived loudness. 4. Dial in the Leveler and Channel Link
Turn Auto Output Gain OFF to maintain manual control over your headroom and output ceiling.
Link the stereo channels by at least 50% to stabilize the center image of the mix when compression hits heavily.
Turn up the Leveler control. The leveler behaves like a macro-dynamics compressor (combining threshold, knee, and ratio). Driving it pushes up the quiet passages, gluing the audio track together before it even hits the brickwall stage. 5. Use the “Serial Limiting” Pro-Trick PSP Xenon = can it go loud? – Gearspace
Leave a Reply